2011-2016 FJ Cruiser · Service Manual SUSPENSION & AXLE

INSPECTION

Inspection · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


INSPECT TIRES
  1. Check the tires for wear and proper inflation pressure.

    Cold Tire Inflation Pressure:
    Tire Size
    Front Wheel
    kPa (kgf/cm2, psi)
    Rear Wheel
    kPa (kgf/cm2, psi)
    265/70R17 115S
    220 (2.2, 32)
    220 (2.2, 32)

  1. R003031
    Using a dial indicator, check the tire runout.

    Tire runout:
    3.0 mm (0.118 in.) or less


ROTATE TIRES

C168866E02

HINT:
See the illustration on the left for how to rotate the tires, when you include the spare tire in the rotation.
Text in Illustration 
*A
for Part Time 4WD
*B
for Full Time 4WD
*a
Front of the Vehicle


INSPECT WHEEL BALANCE

C080976
  1. Perform off-car balancing.

  1. If necessary, perform on-car balancing.

    Imbalance after adjustment:
    6 g (0.013 lb) or less


INSPECT FRONT AXLE HUB BEARING

F042746
  1. Inspect the axle hub backlash.

    1. Using a dial indicator, check the backlash near the center of the axle hub.

      Maximum:
      0.05 mm (0.0020 in.)

      If the backlash is greater than the maximum, replace the bearing.

  1. F042745
    Inspect the axle hub runout.

    1. Using a dial indicator, check the runout of the surface of the axle hub.

      Maximum:
      0.05 mm (0.0020 in.)

      If the runout is greater than the maximum, replace the bearing.


INSPECT REAR AXLE SHAFT BEARING

F042748
  1. Inspect the axle shaft backlash.

    1. Using a dial indicator, check the backlash near the center of the axle shaft.

      Maximum:
      0.05 mm (0.0020 in.)

      If the backlash is greater than the maximum, replace the bearing.

  1. F042747
    Inspect the axle shaft runout.

    1. Using a dial indicator, check the runout of the surface of the axle shaft.

      Maximum:
      0.05 mm (0.0020 in.)

      If the runout is greater than the maximum, replace the bearing.

← INSPECTION (Jul 2007 – Oct 2010)PRECAUTION (from Jul 2007) →