REMOVAL
Removal / installation · Vehicles built Jul 2007 – Oct 2010
Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012
| 2.
DISCONNECT CLUTCH RESERVOIR TUBE |
|
| 3.
DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE |
 |
Using a union nut wrench, disconnect the flexible hose tube.
| 4.
REMOVE FRONT FLOOR FOOTREST
|
 |
- Disengage the 4 claws and remove the front floor footrest.
| 5.
REMOVE FRONT DOOR SCUFF PLATE LH
|
 |
- HINT:
- Use the same procedure as for the RH side.
| 6.
REMOVE COWL SIDE TRIM BOARD LH
|
 |
- HINT:
- Use the same procedure as for the RH side.
| 7.
REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY
|
 |
- Disengage the 4 clips and 2 claws and remove the instrument panel register.
- NOTICE:
- To avoid breakage of the register, remove the instrument panel register with the shut damper of the register open.
- Pull the instrument panel register up diagonally to remove it.
| 8.
REMOVE LOWER LH INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
|
 |
- Remove the 2 <F> bolts.
Disengage the 5 clips and claw and remove the lower instrument panel finish panel.
| 9.
REMOVE INSTRUMENT PANEL LOWER LH
|
 |
- Remove the 4 <F> bolts and remove the lower instrument panel.
| 10.
SEPARATE DRIVER SIDE JUNCTION BLOCK
|
 |
- Remove the 2 nuts and separate the main body ECU.
| 11.
REMOVE CLUTCH PEDAL WITH CLUTCH MASTER CYLINDER |
 |
Disconnect the clutch switch connector.
- Remove the 2 nuts and bolt, then remove the clutch pedal with clutch master cylinder.
| 12.
REMOVE CLUTCH MASTER CYLINDER ASSEMBLY |
 |
Disconnect the clutch reservoir tube.
- Using a union nut wrench, disconnect the 2 way tube from the clutch master cylinder.
- Remove the clip and the pin and separate the push rod clevis from the clutch pedal.
- Remove the 2 bolts, then remove the clutch master cylinder.