SYSTEM DESCRIPTION
Troubleshooting · Vehicles built Aug 2011 – Jul 2012
Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012
| BRIEF DESCRIPTION |
The CAN (Control Area Network) is a serial data communication system for real time application. It is a vehicle multiplex communication system which has a high communication speed (500 kbps) and the ability to detect malfunctions.
By pairing the CANH and CANL bus lines, the CAN performs communication based on differential voltages.
Many ECUs (sensors) installed on the vehicle operate by sharing information and communicating with each other.
The CAN has two 120 Ω resistors which are necessary to communicate with the main wire.
| DEFINITION OF TERMS |
Main wire
The main wire is a wire harness between the two terminus circuits on the bus (communication line). This is the main bus in the CAN communication system.
Branch wire
The branch wire is a wire harness which diverges from the main wire to an ECU or a sensor.
Terminus circuit
The terminus circuit is a circuit which converts the communication current of the CAN communication into the bus voltage. It consists of a resistor and condenser. Two terminus circuits are necessary on a bus.
CAN Junction Connector
The CAN junction connector is a junction designed for CAN communication, which contains terminus circuits.
| ECUs OR SENSORS WHICH COMMUNICATE VIA CAN COMMUNICATION SYSTEM |
Skid control ECU
ECM
Steering angle sensor
Yaw rate sensor
Combination meter ECU
Airbag sensor assembly
| DIAGNOSTIC CODES FOR CAN COMMUNICATION SYSTEM |
DTCs for the CAN communication system are as follows: U0073, U0100, U0123, U0124, U0126, U0129 and U0151.
| NOTES REGARDING TROUBLESHOOTING |
Trouble in the CAN bus (communication line) can be checked through the DLC3 (except when there is a wire break other than in the branch wire of the DLC3).
- NOTICE:
- Do not connect the tester directly to the DLC3 connector. Be sure to use a service wire.
DTCs regarding the CAN communication system can be checked using the intelligent tester.
The CAN communication system cannot detect trouble in the branch wire of the DLC3 even though the DLC3 is also connected to the CAN communication system.