2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

SYSTEM DESCRIPTION

Troubleshooting · Vehicles built from Jul 2007


LIGHTING SYSTEM
  1. Illumination control system (Illuminated entry system):
    When the doors are unlocked through a key or transmitter operation, or when a door is opened or closed, the illuminated entry system turns on the room light assembly.

    1. The main body ECU receives the following signal (A).

      1. Door courtesy switch signal
      2. Door detection switch signal
      3. Ignition switch signal

    2. The main body ECU controls the following signal based on the signals listed in A.

      1. Illumination operation signal

    3. The main body ECU controls the on/off and fade-in/fade-out operation of the following parts.

      1. Room light assembly
      1. Transponder key amplifier (Ignition key cylinder light)

  2. Battery saver system:
    When the ignition switch is turned off and any of the doors is open continuously for 30 minutes, the main body ECU turns the illumination operation signal off. As a result, the room light assembly, taillights, and the headlights turn off.

    1. The main body ECU receives the following signals (B).

      1. Door courtesy switch signal
      2. Ignition switch signal

    2. The main body ECU controls the following signal based on the signals listed in B (C).

      1. Illumination operation signal

    3. The main body ECU controls the illumination period of the following parts based on the signals listed in C.

      1. Room light assembly
      2. Headlight (Low)
      3. Position light (Front and Rear)

  3. Manual light control system:
    This system functions when lights such as the headlights and taillights are illuminated through manual operation of the light control switch.

    1. The main body ECU receives the following signals (D).

      1. Light control switch signal
      2. Headlight dimmer switch signal

    2. The main body ECU controls the following signals based on the signals listed in D (E).

      1. HEAD relay operation signal
      2. TAIL relay operation signal

    3. The main body ECU controls the on/off operation of the following parts based on the signals listed in E.

      1. Headlight (Low)
      2. Headlight (High)
      3. Position light (Front and Rear)

  4. Light auto turn off system:
    With the light control switch in the TAIL or HEAD position, the headlights and taillights go off immediately after the ignition switch is turned off and the driver door is opened.

    1. The main body ECU receives the following signals (F).

      1. Door courtesy switch signal
      2. Ignition switch signal

    2. The main body ECU controls the following signals based on the signals listed in F (G).

      1. HEAD relay operation signal
      2. TAIL relay operation signal

    3. The main body ECU controls the illumination period of the following parts based on the signals listed in G.

      1. Headlight (Low)
      2. Headlight (High)
      3. Position light (Front and Rear)

  5. Manual headlight level control system:

    1. When the vehicle posture changes in accordance with the number (weight) of passengers and volume of luggage, this system enables manual adjustment of the LO beam level of the headlights to an appropriate level by using the headlight leveling switch.

      1. The beam level of the headlights can be adjusted by the headlight leveling motor installed in the headlight assembly.
      2. A headlight leveling switch is provided to allow the driver to control this system.

← SYSTEM DIAGRAM (from Aug 2012)HOW TO PROCEED WITH TROUBLESHOOTING (Jul 2007 – Oct 2010) →