2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Jul 2007


INSPECT HEADLIGHT LEVELING SWITCH

E154416E01
  1. Check the ratio.

    1. Connect the positive (+) battery lead to terminal 1 and the negative (-) battery lead to terminal 2.

    2. Check the ratio which is obtained by dividing the voltage between terminals 2 and 4(5) by the voltage between 1 and 2. The voltages must be measured using a voltmeter.

      Standard Ratio:
      Tester Connection
      Switch Position
      Specified Condition
      1 - 2 and 2 - 4(5)
      0
      0.87 to 0.93
      1 - 2 and 2 - 4(5)
      1
      0.72 to 0.76
      1 - 2 and 2 - 4(5)
      2
      0.56 to 0.60
      1 - 2 and 2 - 4(5)
      3
      0.41 to 0.43
      1 - 2 and 2 - 4(5)
      4
      0.25 to 0.27
      1 - 2 and 2 - 4(5)
      5
      0.09 to 0.10

      If the result is not as specified, replace the headlight leveling switch.

  1. Check the illumination operation.

    1. Connect the positive (+) battery lead to terminal 3 and the negative (-) battery lead to terminal 6, then check that the illumination illuminates.

      Ok:
      Illumination illuminates.

      If the illumination does not illuminate, replace the headlight leveling switch.

← REMOVAL (from Nov 2010)INSTALLATION (Jul 2007 – Oct 2010) →