ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jul 2007
| INSPECT TURN SIGNAL FLASHER CIRCUIT |
![]() ![]() |
Check the power source circuit and ground circuit.
Disconnect the turn signal flasher connector.
Measure the voltage and check the results in accordance with the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
1 - Body ground
Ignition switch off
0 V
1 - Body ground
Ignition switch ON
11 to 14 V
4 - Body ground
Always
11 to 14 V
Measure the resistance and check the result in accordance with the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
7 - Body ground
Always
Below 1 Ω
Check the output operation signal.
Reconnect the turn signal flasher connector.

Measure the voltage and check the results in accordance with the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
2 - Body ground
Hazard warning switch OFF
Below 1 V
2 - Body ground
Hazard warning switch ON
11 to 14 V (60 to 120 times per minute)
2 - Body ground
Ignition switch ON and turn signal switch (right turn) OFF
Below 1 V
2 - Body ground
Ignition switch ON and turn signal switch (right turn) ON
11 to 14 V (60 to 120 times per minute)
3 - Body ground
Hazard warning switch OFF
Below 1 V
3 - Body ground
Hazard warning switch ON
11 to 14 V (60 to 120 times per minute)
3 - Body ground
Ignition switch ON and turn signal switch (left turn) OFF
Below 1 V
3 - Body ground
Ignition switch ON and turn signal switch (left turn) ON
11 to 14 V (60 to 120 times per minute)
5 - Body ground
Ignition switch ON and turn signal switch (left turn) OFF
11 to 14 V
5 - Body ground
Ignition switch ON and turn signal switch (left turn) ON
Below 1 V
6 - Body ground
Ignition switch ON and turn signal switch (right turn) OFF
11 to 14 V
6 - Body ground
Ignition switch ON and turn signal switch (right turn) ON
Below 1 V
8 - Body ground
Hazard warning switch OFF
11 to 14 V
8 - Body ground
Hazard warning switch ON
Below 1 V

