2011-2016 FJ Cruiser · Service Manual TRANSMISSION

MONITOR DRIVE PATTERN

Troubleshooting · Vehicles built from Jul 2007


MONITOR DRIVE PATTERN FOR ECT TEST

  1. Perform this drive pattern as one method to simulate the detection conditions of the ECT (Electronic Controlled Automatic Transmission) malfunctions.
    (The DTCs may not be detected due to the actual driving conditions. And some DTCs may not be detected through this drive pattern.)

    HINT:
    Preparation for driving
    1. Warm up the engine sufficiently. (Engine coolant temperature should be 60°C (140°F) or higher)
    2. Drive the vehicle when the atmospheric temperature is -10°C (14°F) or higher. (Malfunction is not detected when the atmospheric temperature is less than -10°C (14°F))
    Notice in driving
    1. Drive the vehicle through all gears. Stop → 1st → 2nd → 3rd → 4th → 5th → 5th (lock-up ON).
    2. Repeat the above driving pattern three times or more.

    NOTICE:
    1. The monitor status can be checked using the intelligent tester. When using the intelligent tester, monitor status can be found in the "Powertrain / Engine and ECT / Data List".
    2. In the event that the drive pattern must be interrupted (possibly due to traffic conditions or other factors), the drive pattern can be resumed and, in most cases, the monitor can be completed.

    CAUTION:
    Perform this drive pattern on as level a road as possible and strictly observe the posted speed limits and traffic laws while driving.

    C115866E19

    HINT:
    *: Drive at such a speed in the uppermost gear, as to engage lock-up. The vehicle can be driven at a speed lower than that in the above diagram under the lock-up condition.

    NOTICE:
    It is necessary to drive the vehicle for approximately 30 minutes to detect DTC P0711 (ATF temperature sensor malfunction).

← INITIALIZATION (from Nov 2010)PROBLEM SYMPTOMS TABLE (Jul 2007 – Nov 2007) →