2011-2016 FJ Cruiser · Service Manual SECURITIES

ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Aug 2009

Versions by build date: Jul 2007 – Nov 2007 Dec 2007 – Jul 2009 from Aug 2009

DESCRIPTION

This circuit provides power to operate the transponder key ECU.

WIRING DIAGRAM

B175682E03

INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU is replaced, register the key and ECU communication ID.


1. INSPECT FUSE (IGN FUSE)
B175681E01
  1. Remove the IGN fuse.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    IGN fuse
    Always
    Below 1 Ω

    1. Reinstall the IGN fuse.



NG
CHECK FOR SHORTS IN ALL HARNESSES AND CONNECTORS CONNECTED TO FUSE AND REPLACE FUSE
OK


2. INSPECT FUSE (ECU-B FUSE)
B175117E02
  1. Remove the ECU-B fuse.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-B fuse
    Always
    Below 1 Ω

    1. Reinstall the ECU-B fuse.



NG
CHECK FOR SHORTS IN ALL HARNESSES AND CONNECTORS CONNECTED TO FUSE AND REPLACE FUSE
OK


3. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BATTERY)

  1. B164266E27
    Disconnect the E80 transponder key ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E80-1 (+B) - Body ground
    Always
    11 to 14 V
    E80-2 (IG) - Body ground
    Ignition switch OFF
    Below 1 V
    Ignition switch ON
    11 to 14 V

  1. Reconnect the transponder key ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BODY GROUND)

  1. B164266E28
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E80-16 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← ECU Power Source Circuit (Dec 2007 – Jul 2009)COMPONENTS (Jul 2007 – Oct 2010) →