B2784 Antenna Coil Open / Short
Diagnostic trouble codes · Vehicles built Aug 2009 – Oct 2010
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010
DESCRIPTION
The transponder key coil is built into the transponder key amplifier and receives a key code signal from the transponder chip in the key. This signal is amplified by the amplifier, then it is output to the transponder key ECU.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2784 |
Antenna coil is open/shorted |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the transponder key ECU is replaced, register the key and ECU communication ID.
| 1. READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester ON.
Enter the following menus: Body Electrical / Immobiliser / Data List.
According to the display on tester, read the "Data List".
| Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
| Antenna Coil Status |
Transponder key amplifier coil condition/NORMAL or FAIL |
NORMAL: Antenna coil is normal FAIL: Antenna coil is malfunctioning |
- |
- OK:
- NORMAL (Antenna coil is normal) appears on the screen.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER) |
Disconnect the E80 transponder key ECU connectors.

Disconnect the E72 transponder key amplifier connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E80-4 (TXCT) - E72-5 (TXCT)
Always
Below 1 Ω
E80-5 (AGND) - E72-7 (AGND)
Always
Below 1 Ω
E80-14 (VC5) - E72-1 (VC5)
Always
Below 1 Ω
E80-15 (CODE) - E72-4 (CODE)
Always
Below 1 Ω
E80-4 (TXCT) - Body ground
Always
10 kΩ or higher
E80-5 (AGND) - Body ground
Always
10 kΩ or higher
E80-14 (VC5) - Body ground
Always
10 kΩ or higher
E80-15 (CODE) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 3. INSPECT TRANSPONDER KEY ECU (TRANSPONDER KEY AMPLIFIER POWER SOURCE) |
![]() ![]() |
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
E80-14 (VC5) - Body ground
No key is in ignition key cylinder
Below 1 V
Key is in ignition key cylinder
4.6 to 5.4 V
|
|
||||
| OK | |
| 4. INSPECT TRANSPONDER KEY ECU (TRANSPONDER KEY AMPLIFIER GROUND) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
E80-5 (AGND) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||

