2011-2016 FJ Cruiser · Service Manual SECURITIES

SYSTEM DESCRIPTION

Troubleshooting · Vehicles built from Jul 2007


ENGINE IMMOBILISER SYSTEM DESCRIPTION
The engine immobiliser system is designed to prevent the vehicle from being stolen. This system uses the transponder key ECU that stores the key codes of authorized ignition keys. If an attempt is made to start the engine using an unauthorized key, the ECU sends a signal to the ECM to prohibit fuel delivery and ignition, effectively disabling the engine.

FUNCTION OF MAIN COMPONENT
Component
Outline
Transponder key coil/amplifier
When key is inserted in ignition key cylinder, key coil receives key code. Then amplifier amplifies ID code and outputs it to transponder key ECU.
Transponder key ECU
Transponder key ECU verifies transponder key ID code amplified by immobiliser coil/amplifier When key ID code is correct, ECU transmits signal to allow engine to start.
Unlock warning switch
Detects if key is in ignition key cylinder and outputs results to transponder key ECU.
ECM
ECM receives ID verification results from transponder key ECU. ECM also verifies ECUs. Then judgement of whether to immobilise engine is made.
Security indicator
Depending on operation of transponder key ECU, interior security indicator light comes on or starts blinking.

SYSTEM FUNCTION
  1. When the transponder key ECU detects that the key unlock warning switch is ON, the ECU provides current to the transponder key coil and produces an electric wave. A transponder chip in the key grip receives the electric wave. Upon receiving the electric wave, the transponder chip outputs a key ID code signal. The transponder key coil receives this signal, which is amplified by the transponder key amplifier, and the signal is transmitted to the ECU.
    The ECU matches the key's ID code with the vehicle's ID code, which was previously registered in the ECU, and communicates the results to the ECM.
    After the identification results show that the key's ID code matches the vehicle's ID code and the ECU has confirmed their match: 1) the immobiliser system does not immobilise the engine and the engine starting controls (fuel injection control and ignition control) enter standby mode; and 2) the ECU transmits a security indicator signal that communicates "indicator off" to the security indicator light.

  2. The security indicator pattern is as shown below (when changing from the immobiliser set status to the unset status):
    B118503E05

← SYSTEM DIAGRAM (from Jul 2007)HOW TO PROCEED WITH TROUBLESHOOTING (Jul 2007 – Nov 2007) →