2011-2016 FJ Cruiser · Service Manual SECURITIES

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Jul 2007


CHECK FOR IMMOBILISER DTC
  1. Connect a intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the tester ON.

  4. Enter the following menus: Body Electrical / Immobiliser / Trouble Codes.

  5. Check DTCs.

    HINT:
    1. When using intelligent tester with the ignition switch LOCK to troubleshoot: Connect the intelligent tester to the vehicle, and turn the front door courtesy light switch LH on and off at 1.5 second intervals until communication between the tester and vehicle begins.
    2. Refer to the intelligent tester operator's manual for further details.


CHECK FOR ECM DTC
  1. Connect a intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the tester ON.

  4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  5. Check DTCs.


CLEAR FOR IMMOBILISER DTC
  1. Connect a intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the tester ON.

  4. Enter the following menus: Body Electrical / Immobiliser / Trouble Codes.

  5. Clear the DTCs.

    HINT:
    1. When using intelligent tester with the ignition switch LOCK to troubleshoot: Connect the intelligent tester to the vehicle, and turn the front door courtesy light switch LH on and off at 1.5 second intervals until communication between the tester and vehicle begins.
    2. Refer to the intelligent tester operator's manual for further details.


CLEAR FOR ECM DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the tester ON.

  4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  5. Clear the DTCs.

← DIAGNOSIS SYSTEM (from Jul 2007)DATA LIST / ACTIVE TEST (Jul 2007 – Jul 2009) →