2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

TERMINALS OF ECU

System information · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


CHECK RADIO RECEIVER
E130763E01
  1. Disconnect the E41 receiver connector.

  2. Measure the resistance and voltage of the wire harness side connector.

    Standard: 
    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    E41-7 (GND) - Body ground
    BR - Body ground
    Ground
    Always
    Below 1 Ω
    E41-4 (B) - E41-7 (GND)
    L-Y - BR
    Battery
    Always
    11 to 14 V
    E41-3 (ACC) - E41-7 (GND)
    GR -BR
    ACC power supply
    Ignition switch OFF
    Below 1 V
    Ignition switch ACC
    11 to 14 V

    HINT:
    If the results are not as specified, there may be a malfunction in the wire harness.

  3. Reconnect the E41 receiver connector.

  4. Measure the voltage of the connector.

    Standard voltage: 
    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specification
    E41-10 (ILL+) - E41-7 (GND)
    G - BR
    Illumination signal
    Light control switch OFF
    Below 1 V
    Light control switch TAIL
    11 to 14 V
    E42-5 (ILL-) - E41-7 (GND)
    BR-W - BR
    Illumination signal
    Light control switch OFF
    Below 1 V
    Light control switch TAIL
    11 to 14 V
    E41-1 (FR+) - E41-7 (GND)
    LG - BR
    Sound signal (Front right)
    Audio system is playing
    A waveform synchronized with sound is output
    E41-5 (FR-) - E41-7 (GND)
    L - BR
    Sound signal (Front right)
    Audio system is playing
    A waveform synchronized with sound is output
    E41-2 (FL+) - E41-7 (GND)
    P - BR
    Sound signal (Front left)
    Audio system is playing
    A waveform synchronized with sound is output
    E41-6 (FL-) - E41-7 (GND)
    V - BR
    Sound signal (Front left)
    Audio system is playing
    A waveform synchronized with sound is output
    E42-1 (RR+) - E41-7 (GND)
    R - BR
    Sound signal (Rear right)
    Audio system is playing
    A waveform synchronized with sound is output
    E42-3 (RR-) - E41-7 (GND)
    W - BR
    Sound signal (Rear right)
    Audio system is playing
    A waveform synchronized with sound is output
    E42-2 (RL+) - E41-7 (GND)
    B - BR
    Sound signal (Rear left)
    Audio system is playing
    A waveform synchronized with sound is output
    E42-6 (RL-) - E41-7 (GND)
    Y - BR
    Sound signal (Rear left)
    Audio system is playing
    A waveform synchronized with sound is output
    E41-9 (AMP) - E41-7 (GND)*1
    P-L - BR
    Woofer speaker signal
    Woofer speaker switch OFF
    Below 1 V
    Woofer speaker switch ON
    11 to 14 V
    E43-6 (SWG) - E41-7 (GND)
    W-R - BR
    Steering pad switch ground
    Always
    Below 1 V
    E43-7 (SW1) - E41-7 (GND)
    V-W - BR
    Steering pad switch signal
    Steering pad switch not operated
    4 V or more
    SEEK+ switch pushed
    Approximately 0.5 V
    SEEK- switch pushed
    Approximately 0.9 V
    VOL+ switch pushed
    Approximately 2.0 V
    VOL- switch pushed
    Approximately 3.4 V
    E43-8 (SW2) - E41-7 (GND)
    Y-B - BR
    Steering pad switch signal
    Steering pad switch not operated
    4 V or more
    MODE switch pushed
    Approximately 0.5 V
    ON HOOK switch pushed
    Approximately 0.9 V
    OFF HOOK switch pushed
    Approximately 2.0 V
    VOICE switch pushed
    Approximately 3.4 V
    E43-15 (ARI) - E41-7 (GND)
    P - BR
    Sound signal (Right)
    External device is playing (When stereo jack adapter is used)
    A waveform synchronized with sound is output
    E43-16 (ASGN) - E41-7 (GND)
    (Shielded) - BR
    Ground (Shielded)
    Always
    Below 1 V
    E43-17 (ALI) - E41-7 (GND)
    L - BR
    Sound signal (Left)
    External device is playing (When stereo jack adapter is used)
    A waveform synchronized with sound is output
    E43-19 (AUXI) - E41-7 (GND)
    P-G - BR
    External device connection detection signal
    External device is connected
    Below 1 V
    *1: w/ Woofer Speaker

    HINT:
    If the results are not as specified, there may be a malfunction in the wire harness.

← PROBLEM SYMPTOMS TABLE (from Aug 2012)TERMINALS OF ECU (from Nov 2010) →