2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Radio Broadcast cannot be Received (Bad Reception)

Circuit diagnosis · Vehicles built from Aug 2011

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2011 from Aug 2011

INSPECTION PROCEDURE


1. CHECK WHETHER RAPID TEMPERATURE CHANGE OCCURRED IN CABIN
  1. Check whether the radio auto-search functions properly.

    1. Tune the radio using the auto-search function and check that it operates normally.

      OK:
      The radio auto-search functions properly.



OK
END
NG


2. CHECK OPTIONAL COMPONENTS
  1. Check whether any optional components, such as telephone antenna, are installed.

    OK:
    Optional component(s) installed.



OK
EFFECT FROM OPTIONAL COMPONENTS
NG


3. CHECK ANTENNA FOR NOISE PRODUCTION
  1. With the ignition switch ON, turn on the radio and select the AM mode.

  1. Place the tip of a screwdriver on the antenna and check that noise is heard from the speakers.

    OK:
    Noise occurs.



OK
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
NG


4. INSPECT RADIO RECEIVER ASSEMBLY (ANTENNA)

  1. E130764
    Remove the antenna plug of the radio receiver.

  1. With the radio receiver connector connected, turn the ignition switch ACC.

  1. Turn on the radio and select the AM mode.

  1. Place a flat-head screwdriver or piece of metal, such as a thin wire, on the antenna jack of the radio receiver. Check that noise is heard from the speakers.

    OK:
    Noise occurs.



NG
REPLACE ROOF ANTENNA POLE SUB-ASSEMBLY (Click here)
OK

REPLACE RADIO RECEIVER (Click here)


← Radio Broadcast cannot be Received (Bad Reception) (Nov 2010 – Jul 2011)Poor Sound Quality in All Modes (Low Volume) (Jul 2007 – Oct 2010) →