2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Sound Signal Circuit between Multi-media Interface ECU and Stereo Jack Adapter

Circuit diagnosis · Vehicles built from Nov 2010

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal of an external device to the multi-media interface ECU through this circuit.

WIRING DIAGRAM

E193011E39

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - NO. 1 STEREO JACK ADAPTER)
  1. Disconnect the E94 multi-media interface ECU connector.

  1. Disconnect the E93 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E93-3 - E94-3
    Always
    Below 1 Ω
    E93-2 - E94-2
    Always
    Below 1 Ω
    E93-3 - Body ground
    Always
    10 kΩ or higher
    E93-2 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter (from Nov 2010)Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier (from Nov 2010) →