INSTALLATION
Removal / installation · Vehicles built from Aug 2011
Versions by build date: Jul 2007 – Jul 2011 from Aug 2011
| 1. INSTALL RADIO ANTENNA POLE SUB-ASSEMBLY |
Install the radio antenna pole sub-assembly by hand until fully seated.

Text in Illustration *a
1/8 turn (20 to 45 degrees)
Using a 8 mm (5/16 inch) wrench, fully tighten the radio antenna pole about 1/8 turn (20 to 45 degrees) by turning it clockwise.
- NOTICE:
- Do not over tighten. Tighten with finger, not hand.
- Do not use pliers to tighten the radio antenna pole as it can leave marks on the radio antenna pole surface.
- The antenna pole cannot be hand tightened to the proper specification.
- Do not over tighten. Tighten with finger, not hand.
- Torque:
- 3.3 N*m{ 34 kgf*cm , 29 in.*lbf }
