2011-2016 FJ Cruiser · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009


1. REMOVE STARTER YOKE ASSEMBLY

  1. A074096
    Remove the nut, then disconnect the lead wire from terminal C.

  1. Remove the 2 through bolts.

  1. Pull the starter yoke and the armature out together.

  1. Remove the O-ring from the starter yoke.


2. REMOVE MAGNET STARTER SWITCH ASSEMBLY

  1. A074097
    Remove the 2 screws, then remove the magnet starter switch.

  1. A062427
    Remove these parts from the starter drive housing.
    (1)
    Starter magnet switch return spring
    (2)
    Starter idle gear pinion
    (3)
    Starter idle gear clutch roller
    (4)
    Starter idle gear retainer
    (5)
    Starter clutch

  1. ST00948
    Using a magnetic finger, remove the steel ball from the clutch shaft hole.


3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

  1. A062428
    Remove the 2 screws, then remove the end frame from the starter yoke.

  1. Remove the O-ring from the starter yoke.

  1. A062429
    Using a screwdriver, hold the spring back and disconnect the 4 brushes from the brush holder.

  1. Remove the brush holder from the armature.


4. REMOVE STARTER ARMATURE ASSEMBLY
  1. Remove the starter armature from the starter yoke.

← REMOVAL (from Aug 2014)DISASSEMBLY (from Aug 2009) →