2011-2016 FJ Cruiser · Service Manual BODY

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Jul 2007 – Jul 2014 from Aug 2014


1. REMOVE NO. 3 ENGINE ROOM WIRE

  1. B376798
    Disconnect the 2 connectors.

  1. Disengage the 7 clamps to remove the No. 3 engine room wire.

  1. Using an infrared light, heat the ultrasonic sensor retainer.

    Heating Temperature 
    Item
    Temperature
    Front Bumper Cover
    20 to 30°C (68 to 86°F)

    CAUTION:
    Do not burn yourself with the heated front bumper cover or infrared light.

    NOTICE:
    1. Do not heat the front bumper cover excessively.
    2. Remove any tape remaining on the front bumper cover.

  1. Remove the 7 ultrasonic sensor retainers while peeling off the double-sided tape.

    B370393


2. REMOVE FRONT BUMPER PAD LH

  1. B387231
    Remove the 6 retainers.

  1. Disengage the 4 claws and remove the front bumper pad LH.


3. REMOVE FRONT BUMPER PAD RH

HINT:
Use the same procedure as for the LH side.


4. REMOVE FRONT BUMPER HOLE COVER LH (w/ Fog Light)

  1. B377694
    Remove the screw.

  1. B380475
    Disengage the 3 claws and guide to remove the front bumper hole cover LH.


5. REMOVE FRONT BUMPER HOLE COVER RH (w/ Fog Light)

HINT:
Use the same procedure as for the LH side.


6. REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)

  1. B370391
    Remove the 2 screws.

  1. B370374
    Disengage the 2 guides to remove the fog light assembly with front bumper side retainer.

  1. B381717
    Remove the 2 screws and fog light assembly.


7. REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)

HINT:
Use the same procedure as for the LH side.


8. REMOVE RADIATOR LOWER GRILLE

  1. B135068
    Disengage the 11 claws and remove the radiator lower grille.


9. REMOVE FRONT VALANCE LOWER PANEL

  1. B135069
    Remove the 6 nuts.

  1. Disengage the 5 claws and remove the front valance lower panel.

← DISASSEMBLY (Jul 2007 – Jul 2014)REASSEMBLY (Jul 2007 – Jul 2014) →