2011-2016 FJ Cruiser · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Oct 2012 from Nov 2012

HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Back Sonar)

2. REMOVE REAR BUMPER COVER

  1. B135140E01
    Apply protective tape as shown in the illustration.

  1. B135141
    Remove the 7 bolts and the 2 screws.

  1. B135142
    w/ Back Sonar:

    1. Disconnect the 2 wire to wire connectors.

  1. B135143
    Disengage the 6 claws and the 2 clips and remove the rear bumper cover.


3. REMOVE FRONT FENDER MUDGUARD

  1. B135082
    Using a clip remover, remove the clip.

  1. Remove the 5 screws and the front fender mudguard.


4. REMOVE QUARTER PANEL MUDGUARD

  1. B135084
    Using a clip remover, remove the clip.

  1. Remove the 4 screws and the quarter panel mudguard.

← COMPONENTS (from Jul 2007)REMOVAL (Nov 2010 – Oct 2012) →