2011-2016 FJ Cruiser · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built Aug 2012 – Jul 2014

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Jul 2012 Aug 2012 – Jul 2014 from Aug 2014


INSPECT FUEL PUMP ASSEMBLY

  1. A176427E01
    Check the resistance.
    Text in Illustration 
    *a
    Component without harness connected
    (Fuel Pump)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      0.2 to 3.0 Ω

      If the result is not as specified, replace the fuel pump.

  1. A223267E02
    Check the operation.
    Text in Illustration 
    *a
    Component without harness connected
    (Fuel Pump)

    1. Apply battery voltage between the terminals and check that the pump operates.
      If the result is not as specified, replace the fuel pump and fuel pump ECU.

      NOTICE:
      1. This inspection must be done quickly (within 10 seconds) to prevent the coil from burning out.
      2. Keep the pump as far away from the battery as possible.
      3. Always do the switching (voltage on/off) at the battery terminal.
      4. When the pump is locked and does not operate due to foreign matter being stuck, etc., replace the fuel pump ECU (Click here) together with the fuel pump, as the fuel pump ECU may be damaged electrically.

← INSPECTION (Aug 2009 – Jul 2012)INSPECTION (from Aug 2014) →