2011-2016 FJ Cruiser · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009


INSPECT RADIATOR CAP SUB-ASSEMBLY

A138101

  1. Measure the valve opening pressure.

    1. If there are water stains or foreign matter on rubber packings 1, 2 or 3, clean the parts with water and finger scouring.

    2. Check that rubber packings 1, 2 or 3, is not deformed, cracked or swollen.

    3. Check that rubber packings 3 and 4 are not stuck together.

    4. Apply engine coolant to rubber packings 2 and 3 before using the radiator cap tester.

    5. Z000570E05
      When using the cap tester, tilt it to more than 30 degrees.

    6. Pump the cap tester several times, and check the maximum pressure *1.

      Pumping speed:
      1 pump per second.

      *1: Even if the cap cannot maintain the maximum pressure. it is not a defect.

      Judgement criteria:
      Item
      Specified Condition
      Standard value (for brand new cap)
      93 to 123 kPa (0.95 to 1.25 kgf*cm2, 13.5 to 17.8 psi)
      Minimum standard value (after using cap)
      78 kPa (0.8 kgf*cm211.4 psi)

      If the maximum pressure is less than the specified pressure for the minimum standard value, replace the radiator cap sub-assembly.

← COMPONENTS (from Aug 2014)ON-VEHICLE INSPECTION (from Aug 2009) →