REMOVAL
Removal / installation · Vehicles built from Aug 2012
Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012
| 1.
PRECAUTION |
 |
(Click here)
| 2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 3.
PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
|
| 4.
REMOVE STEERING WHEEL COVER LOWER NO.3
|
 |
- Using a thin-bladed screwdriver, remove steering wheel cover lower No.3.
- HINT:
- Tape up the screwdriver tip before use.
| 5.
REMOVE STEERING WHEEL COVER LOWER NO.2
|
 |
- Using a thin-bladed screwdriver, remove steering wheel cover lower No.2.
- HINT:
- Tape up the screwdriver tip before use.
| 6.
REMOVE STEERING PAD
|
 |
- Using "Torx" socket wrench (T30), loosen the 2 "Torx" screws until the groove along the screw circumference catches on the screw case.
- Pull the steering pad out of the steering wheel assembly and support the steering pad with one hand as shown in the illustration.
- NOTICE:
- When removing the steering pad, do not pull the airbag wire harness.
Disconnect the horn connector.
Disconnect the 2 connectors from the steering pad.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Remove the steering pad.
| 7.
REMOVE STEERING WHEEL ASSEMBLY
|
 |
Text in Illustration
*a
|
Matchmark
|
*b
|
Hold
|
*c
|
Turn
|
Remove the steering wheel assembly set nut.
Put matchmarks on the steering wheel assembly and the main shaft assembly.
Using SST, remove the steering wheel assembly.
- SST
- 09950-50013
(09951-05010, 09952-05010, 09953-05020, 09954-05021)
- NOTICE:
- Apply a small amount of grease to the threads and tip of SST (center bolt) before use.
| 8.
REMOVE LOWER STEERING COLUMN COVER
|
 |
Remove the 3 screws.
Disengage the 2 claws and remove the lower steering column cover.
| 9.
REMOVE UPPER STEERING COLUMN COVER
|
 |
Disengage the claw and remove the upper steering column cover.
| 10.
REMOVE SPIRAL CABLE
|
 |
- Disconnect the connectors from the spiral cable.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
- Disengage the 4 screws and remove the spiral cable.
| 11.
REMOVE STEERING ANGLE SENSOR |
 |
Disconnect the steering angle sensor connector.
- Disengage the claw and disconnect the steering angle sensor connector and harness.
- Disengage the 2 claws and remove the steering angle sensor.