INSTALLATION
Removal / installation · Vehicles built from Jul 2007
| 1.
INSTALL REAR STABILIZER BUSH |
 |
Install the 2 stabilizer bushes onto the stabilizer bar.
- HINT:
- Install the stabilizer bush onto the outer side of the bush stopper on the stabilizer bar.
| 2.
INSTALL REAR STABILIZER BAR |
 |
Install the stabilizer bar and 2 stabilizer bracket covers with the 4 bolts.
-
Torque:
- 30 N*m{
306 kgf*cm
, 22 ft.*lbf
}
| 3.
INSTALL REAR STABILIZER LINK ASSEMBLY |
 |
Install the stabilizer link with the nut.
-
Torque:
- 70 N*m{
714 kgf*cm
, 52 ft.*lbf
}
- HINT:
- If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.
Install the 2 No. 1 retainers, 2 cushions and No. 2 retainer.
- While holding the stabilizer link with a spanner, install a new nut.
-
Torque:
- 15 N*m{
153 kgf*cm
, 11 ft.*lbf
}
The installation procedure for the RH side is the same as that for the LH side.
| 4.
INSTALL REAR WHEEL |
 |
-
Torque:
- 112 N*m{
1,137 kgf*cm
, 82 ft.*lbf
}