DISASSEMBLY
Removal / installation · Vehicles built from Jul 2007
| 1. INSPECT FRONT PROPELLER SHAFT ASSEMBLY |
Check that the propeller shaft is not damaged or deformed.
If necessary, replace the propeller shaft.
Using a dial indicator, check the propeller shaft runout.

- Maximum runout:
- 0.3 mm (0.012 in.)
| 2. INSPECT UNIVERSAL JOINT SPIDER BEARING |
Check that the joints move smoothly.
Check the spider bearings for wear and damage.
Check the spider bearing axial play by turning the yoke while holding the shaft tightly.
- Maximum bearing axial play:
- 0 mm (0 in.)
| 3. REMOVE FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER KIT |
Place matchmarks on the flange yoke and sleeve yoke.

Using a brass bar and a hammer, slightly tap in the spider bearing outer races.

Using 2 screwdrivers, remove the 4 snap rings from the grooves.
Using SST, push out the spider bearing from the propeller shaft.

- SST
- 09332-25010
- HINT:
- Sufficiently raise the part indicated by (A) so that it does not come into contact with the spider bearing.
Clamp the spider bearing outer race in a vise and tap off the propeller shaft with a hammer.

- NOTICE:
- Do not tap the shaft.
- HINT:
- Remove the bearing on the opposite side in the same procedure.
Install the 2 removed spider bearing outer races onto the spider.

Using SST, push the bearing out of the yoke.
- SST
- 09332-25010
- HINT:
- Sufficiently raise the part indicated by (A) so that it does not come into contact with the bearing.
Clamp the outer bearing race in a vise and tap off the flange yoke with a hammer.

Remove the spider.
