2011-2016 FJ Cruiser · Service Manual DRIVE LINE

REMOVAL

Removal / installation · Vehicles built from Jul 2007


1. DRAIN TRANSFER OIL

2. REMOVE LOWER TRANSFER CASE PROTECTOR

  1. C133827
    Remove the brake hose clamp.

  1. Remove the 5 bolts and protector.


3. REMOVE REAR PROPELLER SHAFT ASSEMBLY

C098699E02
  1. Place matchmarks on the propeller shaft flange and transfer flange.

  1. Remove the 4 nuts and 4 washers.

  1. C098700E02
    Place matchmarks on the propeller shaft flange and differential flange.

  1. Remove the 4 nuts, 4 bolts, 4 washers and the propeller shaft assembly.


4. REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
  1. Remove the companion flange (rear) in the same way as the companion flange (front).

    SST
    09330-00021  
    09950-40011   (09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04051, 09957-04010, 09958-04011)


5. REMOVE TRANSFER OUTPUT SHAFT COMPANION FLANGE OIL SEAL
  1. Using a screwdriver and hammer, tap out the oil seal from the companion flange.

    NOTICE:
    Be careful not to damage the oil seal and companion flange contact surfaces.


6. REMOVE EXTENSION HOUSING OIL SEAL

F043484E01
  1. Using SST, tap out the oil seal.

    SST
    09308-00010  

    NOTICE:
    Be careful not to damage the oil seal and extension housing contact surface.

← COMPONENTS (from Jul 2007)INSTALLATION (from Jul 2007) →