2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jul 2007


1. INSTALL ACCESS PANEL UPPER LOCK ASSEMBLY

B135532
  1. Install the access panel upper lock with the 3 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

  1. B135531
    Connect the connector, harness clamp and access panel lock control cable.


2. INSTALL CENTER PILLAR UPPER GARNISH

B135560
  1. Engage the 2 clips and install the center pillar upper garnish.

  1. B135559
    Install the 2 screws.

  1. Install the clip.


3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

B135558
  1. Engage the 9 clips and install the rear door trim board.

  1. B135526
    Install the front seat belt outer (floor side) with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }


4. INSTALL NO. 1 CUP HOLDER

B135528
  1. Install the No. 1 cup holder with the screw.


5. INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY

B140033
  1. Install the rear door inside handle with the snap ring onto the access panel inside handle.


6. INSTALL LAP BELT OUTER ANCHOR COVER

B135525
  1. Engage the 3 claws and install the lap belt outer anchor cover.


7. INSTALL ACCESS PANEL REAR WEATHERSTRIP

B135524
  1. Install the access panel rear weatherstrip.


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }

← INSPECTION (from Jul 2007)COMPONENTS (from Jul 2007) →