INSTALLATION
Removal / installation · Vehicles built from Jul 2007
| 1.
INSTALL ACCESS PANEL LOWER LOCK ASSEMBLY |
 |
Install the access panel lower lock onto the rear door.
-
Torque:
- 5.0 N*m{
51 kgf*cm
, 44 in.*lbf
}
- Connect the connector, connector clamp and access panel lock control cable.
| 2.
INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
|
 |
Engage the 9 clips and install the rear door trim board.
- Install the front seat belt outer (floor side) with the bolt.
-
Torque:
- 42 N*m{
428 kgf*cm
, 31 ft.*lbf
}
| 3.
INSTALL NO. 1 CUP HOLDER
|
 |
Install the No. 1 cup holder with the screw.
| 4.
INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY
|
 |
Install the rear door inside handle with the snap ring onto the access panel inside handle.
| 5.
INSTALL LAP BELT OUTER ANCHOR COVER
|
 |
Engage the 3 claws and install the lap belt outer anchor cover.
| 6.
INSTALL ACCESS PANEL REAR WEATHERSTRIP
|
 |
Install the access panel rear weatherstrip.
| 7.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
 |
-
Torque:
- 3.9 N*m{
40 kgf*cm
, 35 in.*lbf
}