2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jul 2007

HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the RH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE ACCESS PANEL REAR WEATHERSTRIP

B135524
  1. Remove the access panel rear weatherstrip.


3. REMOVE LAP BELT OUTER ANCHOR COVER

B135525
  1. Disengage the 3 claws and remove the lap belt outer anchor cover.


4. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY

B135527
  1. Insert a clip remover between the handle and door trim.

  1. Turn the handle with the clip remover inserted, as shown in the illustration.

  1. Remove the rear door inside handle and snap ring.


5. REMOVE NO. 1 CUP HOLDER

B135528
  1. Remove the screw and the No. 1 cup holder.


6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

B135526
  1. Remove the bolt and separate the front seat belt outer (floor side).

  1. B135558
    Disengage the 9 clips and remove the rear door trim panel.


7. REMOVE ACCESS PANEL LOWER LOCK ASSEMBLY

B135561
  1. Disconnect the connector, connector clamp and access panel lock control cable.

  1. B135562
    Using "Torx" socket wrench T30, remove the 3 screws.

  1. Remove the access panel lower lock by sliding it upward.

← COMPONENTS (from Jul 2007)INSPECTION (from Jul 2007) →