ON-VEHICLE INSPECTION
Inspection · Vehicles built Jul 2007 – Oct 2010
Versions by build date: Jul 2007 – Oct 2010 from Nov 2010
| ADJUST PARKING BRAKE SHOE CLEARANCE
|
 |
Provisionally install the 2 hub nuts.
Remove the hole plug, and turn the adjuster to expand the shoe until the disc locks.
Contract the shoe adjuster until the disc rotates smoothly.
- Standard:
- Return 8 notches
Install the hole plug.
| INSTALL REAR WHEEL |
 |
-
Torque:
- 112 N*m{
1,137 kgf*cm
, 82 ft.*lbf
}
| INSPECT PARKING BRAKE LEVER TRAVEL |
 |
Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.
- Parking brake lever travel:
- 5 to 7 clicks at 200 N (20 kgf, 45 lbf)
| REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY
|
 |
Disengage the 2 A claws and 2 B claws.
Slide the parking brake hole cover toward the front of the vehicle, disengage the 2 C claws and remove the parking brake hole cover.
| REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)
|
 |
- Remove the shift lever knob.
| REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
|
 |
- Remove the shift lever knob.
| REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY
|
 |
- Shift the shift lever into the N position.
Disengage the 5 clips and 3 claws and remove the console upper rear panel.
| ADJUST PARKING BRAKE LEVER TRAVEL |
 |
Turn the adjusting nut until the parking brake lever travel is corrected to within the specified range.
- Parking brake lever travel:
- 5 to 7 clicks at 200 N (20 kgf, 45 lbf)
Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.
Check whether the parking brake drags or not.
When operating the parking brake lever, check that the brake warning light illuminates.
- Standard:
- Brake warning light always illuminates at the first click.
| INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY
|
 |
- Engage the 3 claws and 5 clips and install the console upper rear panel.
| INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
|
 |
- Install the shift lever knob.
| INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)
|
 |
- Install the shift lever knob.
| INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY
|
 |
Slide the parking brake hole cover toward the rear of the vehicle and engage the 2 C claws.
Engage the 4 claws and install the parking brake hole cover.