2011-2016 FJ Cruiser · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


1. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY

B133898E02
  1. Disengage the 2 A claws and 2 B claws.

  1. Slide the parking brake hole cover toward the front of the vehicle, disengage the 2 C claws and remove the parking brake hole cover.


2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)

  1. B133893
    Remove the shift lever knob.


3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

  1. B133895
    Remove the shift lever knob.


4. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY

  1. B133897
    Shift the shift lever into the N position.

  1. Disengage the 5 clips and 3 claws and remove the console upper rear panel.


5. REMOVE BOX BOTTOM MAT

  1. B133899
    Remove the box bottom mat.


6. REMOVE FRONT CONSOLE BOX

  1. B133852
    Remove the 2 clips and 2 <F> bolts.

  1. Disengage the 3 clips and 2 claws and remove the instrument lower cover.


7. REMOVE REAR WHEEL

8. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

C133098
  1. Remove the 2 bolts and 2 washers and separate the disc brake caliper assembly.

    NOTICE:
    Suspend the disc brake caliper assembly with a piece of rope.


9. REMOVE REAR DISC
  1. Release the parking brake lever.

  1. D028126E05
    Place matchmarks on the disc and axle hub and remove the disc.

    HINT:
    If the disc cannot be removed easily, turn the shoe adjuster until the wheel turns freely.


10. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING

D028127
  1. Using needle-nose pliers, remove the 2 return tension springs.


11. REMOVE PARKING BRAKE SHOE STRUT
  1. Remove the parking brake shoe strut and compression spring.


12. REMOVE PARKING BRAKE SHOE

D028128
  1. Remove the 2 hold down spring cups, hold down compression spring and hold down spring pin.

  1. Disconnect the return tension spring and remove the No. 2 shoe.

  1. Remove the shoe adjusting screw set and return tension spring.

  1. Remove the 2 hold down spring cups, hold down compression spring and hold down spring pin.

  1. Using needle-nose pliers, disconnect the parking brake cable and remove the No. 1 shoe.


13. REMOVE PARKING BRAKE CABLE HEAT INSULATOR (for RH Side)

C133095
  1. Remove the 2 bolts and the heat insulator.


14. REMOVE PARKING BRAKE CABLE

G022563
  1. Loosen the adjusting nut.

  1. D028481E01
    Disconnect the cable end from the parking brake pull rod.

  1. Contract the claws of the spring cap and push the parking brake cable slightly out of the vehicle.

  1. D028121E01
    Remove the 2 bolts and separate the parking brake cable from the parking brake plate.

  1. Remove the 5 bolts and the parking brake cable.

    C133096


15. REMOVE PARKING BRAKE CABLE CLAMP
  1. Remove the parking brake cable clamp from the parking brake cable.

← COMPONENTS (from Jul 2007)REMOVAL (from Nov 2010) →