2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Jul 2007


INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY

E127252E01
  1. Check the resistance of the hazard warning switch.

    1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      19 - 20
      ON
      Below 3 Ω
      19 - 20
      OFF
      10 MΩ or higher

      If the result is not as specified, replace the integration control and panel.

  1. E127250E01
    Check the illumination operation.

    1. Connect the positive (+) battery lead to terminals 1 and 2, and the negative (-) battery lead to terminal 20, then check that the illumination illuminates.

      Standard:
      Illumination illuminates.

      If the illumination does not illuminate, replace the integration control and panel.

← REMOVAL (from Nov 2010)INSTALLATION (Jul 2007 – Oct 2010) →