2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Woofer Speaker Switch Circuit

Circuit diagnosis · Vehicles built Jul 2007 – Oct 2010

DESCRIPTION

This is the circuit between the radio receiver and the woofer speaker. When the woofer speaker switch is turned ON and OFF, the woofer speaker is activated and deactivated through control of the signals between the receiver and the woofer speaker.
If there is an open or short in the circuit, sound cannot be heard from the woofer speaker even if there is no malfunction in the radio receiver or woofer speaker.

WIRING DIAGRAM

E148141E01

INSPECTION PROCEDURE


1. INSPECT WOOFER SPEAKER SWITCH
  1. Check the woofer speaker switch (Click here).

    OK:
    Woofer speaker switch is normal.



NG
REPLACE WOOFER SPEAKER SWITCH (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - WOOFER SPEAKER SWITCH)

  1. E130775E01
    Disconnect the E41 receiver connector.

  1. Disconnect the E5 woofer speaker switch connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    E41-9 (AMP) - E5-3
    Below 1 Ω
    E41-9 (AMP) or E5-3 - Body ground
    10 kΩ or higher

  1. Reconnect the receiver connector.

  1. Reconnect the woofer speaker switch connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (WOOFER SPEAKER - WOOFER SPEAKER SWITCH)

  1. E130776E01
    Disconnect the K4 woofer speaker connector.

  1. Disconnect the E5 woofer speaker switch connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    K4-9 (AMP+) - E5-4
    Below 1 Ω
    K4-9 (AMP+) or E5-4 - Body ground
    10 kΩ or higher

  1. Reconnect the woofer speaker connector.

  1. Reconnect the woofer speaker switch connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Microphone Circuit between Microphone and Radio Receiver (from Nov 2010)Radio Receiver Communication Error (from Nov 2010) →