2011-2016 FJ Cruiser · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jul 2007


DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

REMOVE STARTER RELAY

A126393E04
  1. Remove the relay block cover upper.

  1. Remove the starter relay.


INSPECT STARTER RELAY

A126370
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      3 - 5
      10 kΩ or higher
      3 - 5
      Below 1 Ω
      (When apply battery voltage to terminals 1 and 2)

      If the result is not as specified, replace the stater relay.


INSTALL STARTER RELAY
  1. Install the starter relay.

  1. Install the relay block cover upper.


CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }

← INSTALLATION (from Aug 2014)COMPONENTS (Jul 2007 – Oct 2010) →