2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Woofer Speaker Power Source Circuit

Circuit diagnosis · Vehicles built Jul 2007 – Oct 2010

DESCRIPTION

This circuit provides power to the woofer speaker.

WIRING DIAGRAM

E154630E01

INSPECTION PROCEDURE


1. INSPECT FUSE (ACC, AM1, RADIO NO. 2)
  1. Remove the ACC fuse from the main body ECU.

  1. Remove the AM1 fuse and RADIO NO. 2 fuse from the engine room R/B.

  1. Measure the resistance of the fuses.

    Standard resistance:
    Below 1 Ω

  1. Reinstall the fuses.



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (WOOFER SPEAKER - BATTERY AND BODY GROUND)

  1. E130761E01
    Disconnect the K4 woofer speaker connector.

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    K4-4 (+B) - Body ground
    Always
    11 to 14 V
    K4-3 (ACC) - Body ground
    Ignition switch ACC
    11 to 14 V

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    K4-7 (GND) - Body ground
    Below 1 Ω

  1. Reconnect the woofer speaker connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Multi-media Interface ECU Power Source Circuit (from Nov 2010)COMPONENTS (Jul 2007 – Oct 2010) →