Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.
2.
REMOVE STEERING WHEEL LOWER COVER LH
Using a thin-bladed screwdriver, remove steering wheel cover lower No.3.
HINT:
Tape up the screwdriver tip before use.
3.
REMOVE STEERING WHEEL LOWER COVER RH
Using a thin-bladed screwdriver, remove steering wheel cover lower No.2.
HINT:
Tape up the screwdriver tip before use.
4.
REMOVE STEERING PAD
Using "Torx" socket wrench (T30), loosen the 2 "Torx" screws until the groove along the screw circumference catches on the screw case.
Pull the steering pad out of the steering wheel assembly and support the steering pad with one hand as shown in the illustration.
NOTICE:
When removing the steering pad, do not pull the airbag wire harness.
Disconnect the horn connector.
Disconnect the 2 connectors from the steering pad.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
Remove the steering pad.
5.
REMOVE STEERING PAD SWITCH
w/ Cruise Control System:
Disconnect the cruise control switch connector.
Disconnect the connector.
Remove the screw.
Disengage the 2 claws and the pin and remove the steering pad switch.