2011-2016 FJ Cruiser · Service Manual DRIVE LINE

INSPECTION

Inspection · Vehicles built from Jul 2007


INSPECT AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR

NOTICE:
When inspecting the actuator, make sure to operate it with the lines connected via a relay. If the lines are not connected via a relay and battery voltage is directly applied to the actuator, the actuator will be damaged.

HINT:
When inspecting the operation described above, use the fuel pump control relay.

  1. Check Free to Lock switch.

    C169041E01

    1. Connect lines via a relay as shown in the illustration, then check that the actuator fork moves from the Free to Lock position.

    2. After the Free to Lock switch is complete, inspect the A.D.D. detection switch and limit switch

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      3 (ADD) - 4 (GND)
      After Free to Lock switch is complete
      Below 12.5 Ω
      5 (DL2) - 4 (GND)
      Below 12.5 Ω
      6 (DL1) - 4 (GND)
      0.5 MΩ or higher

      If there is malfunction, replace the A.D.D. actuator. If the A.D.D. actuator is normal, replace the 4WD control ECU.

  1. Check Lock to Free switch.

    C169040E01

    1. Connect lines via a relay as shown in the illustration, then check that the actuator fork moves from the Lock to Free position.

    2. After the Lock to Free switch is complete, inspect the A.D.D. detection switch and limit switch.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      3 (ADD) - 4 (GND)
      After Lock to Free switch is complete
      0.5 MΩ or higher
      5 (DL2) - 4 (GND)
      0.5 MΩ or higher
      6 (DL1) - 4 (GND)
      Below 12.5 Ω

      If there is malfunction, replace the A.D.D. actuator. If the A.D.D. actuator is normal, replace the 4WD control ECU.

← PARTS LOCATION (from Jul 2007)REPLACEMENT (from Jul 2007) →