2011-2016 FJ Cruiser · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009


INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY
  1. Check the throttle control motor operating sounds.

    1. Turn the ignition switch to ON.

    2. When depressing the accelerator pedal, check the operating sound of the running motor. Make sure that no friction noises emit from the motor. If friction noise exists, replace the throttle body.

  1. Check the throttle position sensor.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Throttle Sensor Volt %.

    5. Depress the accelerator pedal. When the throttle valve is fully opened, check that the value of the "Throttle Sensor Volt %" is within the specification.

      Standard throttle valve opening percentage:
      60% or more

      HINT:
      When checking the standard throttle valve opening percentage, the shift lever should be in N.

      1. If the percentage is less than 60%, replace the throttle body.

← ON-VEHICLE INSPECTION (Jul 2007 – Jul 2009)REMOVAL (Jul 2007 – Jul 2009) →