2011-2016 FJ Cruiser · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2009


1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

  1. A158663
    Temporarily install the sensor to the exhaust pipe by hand.

  1. A229766E01
    Using SST, tighten the sensor.
    Text in Illustration 
    *a
    Fulcrum Length
    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    HINT:
    1. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
    2. The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) (Click here).
    3. This torque value is effective when SST is parallel to the torque wrench.

  1. Connect the sensor connector.


2. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

  1. A158663
    Temporarily install the sensor to the exhaust pipe by hand.

  1. A223690E02
    Using SST, tighten the sensor.
    Text in Illustration 
    *a
    Fulcrum Length
    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    HINT:
    1. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
    2. The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) (Click here).
    3. This torque value is effective when SST is parallel to the torque wrench.

  1. Connect the sensor connector.

← INSPECTION (from Aug 2009)COMPONENTS (from Aug 2009) →