2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

REPLACEMENT

Removal / installation · Vehicles built from Jul 2007


1. REMOVE TRANSMITTER HOUSING COVER

  1. B179421
    Remove the screw and remove the transmitter housing cover.

    NOTICE:
    Do not pry out the transmitter housing cover forcibly.

    HINT:
    Slide the transmitter housing cover with a finger as shown in the illustration, so that there is a small gap, then remove the transmitter housing cover by lifting the hook through the gap.


2. REMOVE DOOR CONTROL TRANSMITTER

  1. B175348
    Remove the door control transmitter.


3. REMOVE TRANSMITTER BATTERY

  1. E114745E01
    Remove the 2 screws and remove the cover.

  1. B175346
    Remove the transmitter battery (lithium battery).

    NOTICE:
    1. Do not push the terminals with your finger.
    2. Forcibly prying up the battery (lithium battery) to remove it will deform the terminals.
    3. Do not touch the battery with wet hands. Water may cause corrosion.
    4. Do not touch or move any components inside the transmitter because handling the components may interfere with proper operation of the transmitter.


4. INSTALL TRANSMITTER BATTERY

  1. E114746
    Install the battery (lithium battery) with the positive (+) side up, as shown in the illustration.

    NOTICE:
    1. Be sure that the positive side and the negative side of the transmitter battery are matched up correctly.
    2. Be careful not to bend the transmitter battery electrode during insertion.
    3. Keep the transmitter case interior free of dust and oil.

  1. E114745E01
    Install the cover with the 2 screws.


5. INSTALL DOOR CONTROL TRANSMITTER

  1. B175348
    Install the door control transmitter.


6. INSTALL TRANSMITTER HOUSING COVER

  1. B179420
    Install the transmitter housing cover with the screw.

    NOTICE:
    If the screws are loose, it may cause faulty contact between the battery (lithium battery) and the terminals.

← COMPONENTS (from Jul 2007)COMPONENTS (from Jul 2007) →