2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

CB-45 USB Communication Error

Diagnostic trouble codes · Vehicles built Nov 2010 – Jul 2012

Also covers:

Versions by build date: Nov 2010 – Jul 2012 from Aug 2012

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
CB-45
Communication error with USB device
  1. Multi-media interface ECU
  2. USB device
CB-46
"iPod" control software malfunction
  1. Multi-media interface ECU
  2. "iPod"
CB-47
Communication error with "iPod"

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs.


1. REPLACE USB DEVICE OR "iPod"
  1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

  1. Turn the ignition switch off.

    HINT:
    When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the ignition switch to ACC.

  1. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

HINT:
  1. If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.


NEXT


2. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3. RECHECK FOR DTC
  1. Recheck for DTCs and check if the same DTC occurs again.

    HINT:
    If DTCs are detected frequently, replace the multi-media interface ECU.

    OK:
    Malfunction disappears.



NG
REPLACE MULTI-MEDIA INTERFACE ECU (Click here)
OK

USB DEVICE OR "iPod" WAS DEFECTIVE


← CB-43 USB Device Class/Protocol Error (+ CB-44, CB-50, CB-51, CB-7D) (from Aug 2012)CB-45 USB Communication Error (+ CB-46, CB-47) (from Aug 2012) →