2011-2016 FJ Cruiser · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2014


1. INSTALL INLET AIR PUMP
  1. Engage the 4 claws to install the inlet air pump to the air pump assembly.


2. INSTALL AIR PUMP INSULATOR
  1. Install the 3 air pump insulators to the No. 1 air pump bracket.


3. INSTALL AIR PUMP ASSEMBLY

  1. A223879E03
    Engage the 3 fittings of the air pump insulator to install the air pump assembly to the No. 1 air pump bracket.
    Text in Illustration 
    *1
    Air Pump Insulator
    *2
    Air Pump Assembly
    *3
    No. 1 Air Pump Bracket

  1. Engage the 2 clamps to connect the wire harness to the No. 1 air pump bracket.

  1. Install the air pump assembly with No. 1 air pump bracket to the vehicle with the 3 bolts.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Engage the clamp to connect the wire harness to the No. 1 air pump bracket.

  1. Connect the air pump assembly connector.


4. CONNECT NO. 1 AIR INJECTION SYSTEM HOSE

  1. A288089E01
    Connect the No. 1 air injection system hose to the air pump assembly and slide the hose clip to secure it as shown in the illustration.
    Text in Illustration 
    *1
    Protrusion of Air Pump Assembly
    *2
    Paint Mark of No. 1 Air Injection System Hose
    *3
    No. 1 Air Injection System Hose
    *a
    View A
    *b
    Upper of Vehicle
    *c
    Front of Vehicle

    HINT:
    1. Make sure the paint mark of the No. 1 air injection system hose is facing upward.
    2. Make sure the direction of the hose clip is as shown in the illustration.


5. INSTALL AIR PUMP COVER
  1. Engage the 3 claws to install the air pump cover to the air pump assembly.

    HINT:
    Make sure the inlet air pump is oriented correctly and completely attached when installing the air pump cover.

← INSPECTION (from Aug 2014)COMPONENTS (from Aug 2014) →