2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Aug 2014

NOTICE:
  1. Use the same procedure for the LH and RH sides.
  2. The procedure described below is for the LH side.


1. INSTALL FOG LIGHT ASSEMBLY
  1. Install the fog light assembly to the front bumper side retainer.

  1. Engage the 2 guides to install the fog light assembly with front bumper side retainer.

  1. Install the 2 screws.


2. INSTALL FRONT BUMPER HOLE COVER

  1. B380475
    Engage the guide and 3 claws to install the front bumper hole cover LH.

  1. B377694
    Install the screw.


3. INSTALL FRONT BUMPER PAD

  1. B387231
    Engage the 4 claws to install the front bumper pad LH.

  1. Install the 6 retainers.


4. INSTALL FRONT BUMPER ASSEMBLY
  1. Install the 4 clips.

  1. w/o Fog Light:

    1. Engage the 2 claws to install the front bumper assembly.

  1. w/ Fog Light:

    1. Connect the connector.

    2. Engage the 2 claws to install the front bumper assembly.

  1. Install the 8 screws and 4 bolts.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf } for screw
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf } for bolt

  1. Install the 5 clips.

  1. Remove the protective tape.


5. INSTALL RADIATOR GRILLE
  1. Engage the 5 clips and install the radiator grille.

  1. Install the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }

  1. Install the 2 clips.


6. ADJUST FOG LIGHT AIMING
(Click here)
← REASSEMBLY (from Aug 2014)COMPONENTS (Jul 2007 – Oct 2010) →