STARTER > REASSEMBLY |
| 1. INSTALL STARTER ARMATURE ASSEMBLY |
Install the starter armature to the starter yoke.
| 2. INSTALL STARTER BRUSH HOLDER ASSEMBLY |
Install the starter brush holder.
![]() |
Connect the 4 brushes to the starter brush holder.
Using a screwdriver, hold back the brush spring.
Connect the brush to the starter brush holder.
Place a new O-ring in position on the commutator end frame.
![]() |
Install the commutator end frame with the 2 screws.
| 3. INSTALL MAGNET STARTER SWITCH ASSEMBLY |
Apply high temperature grease to the idle gear, steel ball, return spring, clutch roller and retainer.
![]() |
Insert the steel ball into the starter clutch.
![]() |
Insert the return spring into the starter clutch.
| *1 | Starter Drive Housing |
| *2 | Starter Clutch |
| *3 | Return Spring |
| *4 | Idle Gear |
| *5 | Retainer |
| *6 | Clutch Roller |
Install the starter clutch, idle gear, retainer and clutch roller to the starter drive housing.
![]() |
Install the starter drive housing to the magnet starter switch with the 2 bolts.
| 4. INSTALL STARTER YOKE ASSEMBLY |
Install a new O-ring to the groove of the starter yoke.
![]() |
Install the starter yoke to the starter switch.
| *a | Groove |
| *b | Claw |
![]() |
Install the starter yoke to the starter switch with the 2 bolts.
Connect the lead wire to terminal C with the nut.