Home › BODY ELECTRICAL › METER › COMBINATION METER

COMBINATION METER > INSTALLATION

for Preparation Click here



1. INSTALL COMBINATION METER ASSEMBLY


    B133863
  1. Connect the 2 connectors and the clamp.



    B133862
  1. Install the combination meter assembly with the 4 screws.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



2. INSTALL INSTRUMENT CLUSTER FINISH PANEL


B133861
  1. Connect the connectors.

  1. Engage the 3 clips and 4 claws and install the instrument cluster lower finish panel.



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B133860
  1. Engage the 5 clips and claw and install the lower instrument panel finish panel.

  1. Connect the connector.

  1. Install the 2 <F> bolts.



4. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B133859
  1. Engage the 3 claws and install the hood lock control lever.



5. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    B133853
  1. Engage the 4 clips and 2 claws and install the instrument panel register.



6. INSTALL INSTRUMENT PANEL GARNISH LH


    B133886
  1. Engage the 3 clips and install the instrument panel garnish.

  1. Install 2 <H> screws.



7. INSTALL COWL SIDE TRIM BOARD LH


E129563
  1. Engage the 2 claws and install the cowl side trim board.

  1. Install the clip.



8. INSTALL FOOTREST CLIP


B130588

HINT:
Use the same procedure for both sides.

  1. Engage the 2 claws and install the footrest clip.



9. INSTALL FRONT FLOOR FOOTREST


    B130589
  1. Engage the 2 studs and install the front floor footrest.



10. INSTALL FRONT DOOR SCUFF PLATE LH


E129562
  1. Engage the 14 claws and install the door scuff plate.



11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }