Home › BODY ELECTRICAL › METER › COMBINATION METER

COMBINATION METER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT DOOR SCUFF PLATE LH


E129562
  1. Disengage the 14 claws and remove the front door scuff plate.



3. REMOVE FRONT FLOOR FOOTREST


    B130586
  1. Disengage the 4 claws and remove the front floor footrest.



4. REMOVE FOOTREST CLIP


    B130587
  1. Remove the 2 footrest clips.



5. REMOVE COWL SIDE TRIM BOARD LH


E129563
  1. Remove the clip.

  1. Disengage the 2 claws and remove the cowl side trim board.



6. REMOVE INSTRUMENT PANEL GARNISH LH


    B133886
  1. Remove screw <H>.

  1. Disengage the 3 clips and remove the instrument panel garnish.

    NOTICE:
    1. Pull the instrument panel garnish up at an angle of 45° to remove it.
    2. Do not damage the surface of the instrument panel when removing it.



7. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    B133853
  1. Disengage the 4 clips and 2 claws and remove the instrument panel register.

    NOTICE:
    1. To avoid breakage of the register, remove the instrument panel register with the shut damper of the register open.
    2. Pull the instrument panel register up diagonally to remove it.



8. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B133859
  1. Disengage the 3 claws and separate the hood lock control lever.



9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


    B133860
  1. Remove the 2 <F> bolts.

  1. Disengage the 5 clips and claw and remove the lower instrument panel finish panel.

  1. Disconnect the connector.



10. REMOVE INSTRUMENT CLUSTER FINISH PANEL


    B133861
  1. Disengage the 3 clips and the 4 claws and remove the instrument cluster finish panel.

  1. Disconnect the connectors.



11. REMOVE COMBINATION METER ASSEMBLY


    B133862
  1. Remove the 4 screws.



    B133863
  1. Disconnect the 2 connectors and clamp and remove the combination meter.