REAR BRAKE > INSPECTION |
| 1. INSPECT BRAKE CYLINDER AND PISTON |
Check the cylinder bore and piston for rust and scoring.
If necessary, replace the disc brake cylinder and piston.
| 2. INSPECT PAD LINING THICKNESS |
![]() |
Using a ruler, measure the pad lining thickness.
| 3. INSPECT REAR DISC BRAKE PAD SUPPORT PLATE |
Make sure that the support plates have sufficient rebound, that there is no deformation, cracks or wear, and that all rust and dirt are removed.
If necessary, replace the disc brake pad support plate.
| 4. INSPECT DISC THICKNESS |
![]() |
Using a micrometer, measure the disc thickness.
| 5. INSPECT DISC RUNOUT |
Check the bearing play in the axial direction and check for the axle hub runout .
![]() |
Provisionally fasten the rear disc together with the hub nuts.
Using a dial indicator, measure the disc runout 10 mm (0.39 in.) away from the outer edge of the rear disc.