Home › BRAKE › BRAKE › REAR BRAKE

REAR BRAKE > DISASSEMBLY

for Preparation Click here



1. REMOVE CYLINDER BOOT


F043127
  1. Using a screwdriver, remove the cylinder boot from the disc brake cylinder.



2. REMOVE REAR DISC BRAKE PISTON


F043128
  1. Place a shop rag or piece of cloth between the piston and disc brake cylinder.

  1. Apply compressed air to remove the piston from the disc brake cylinder.

    CAUTION:
    Do not place your fingers in front of the piston when applying compressed air.

    NOTICE:
    Do not spatter the brake fluid.



3. REMOVE PISTON SEAL


F043129
  1. Using a screwdriver, remove the piston seal from the disc brake cylinder.

    NOTICE:
    Do not damage the inner surface or piston seal groove of the cylinder.



4. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP


5. REMOVE REAR DISC BRAKE BLEEDER PLUG