Home › BRAKE › BRAKE › REAR BRAKE

REAR BRAKE > REASSEMBLY

for Preparation Click here



1. TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG


2. INSTALL REAR DISC BRAKE BLEEDER PLUG CAP


3. INSTALL PISTON SEAL


    C189006E02
  1. Apply lithium soap base glycol grease to a new piston seal.

  1. Install the piston seal onto the disc brake cylinder.

    NOTICE:
    Securely install the piston seal into the groove of the disc brake cylinder.



4. INSTALL REAR DISC BRAKE PISTON


    C190248E01
  1. Apply lithium soap base glycol grease to the piston.

  1. Install the piston into the disc brake cylinder.

    NOTICE:
    Do not forcibly install the piston into the disc brake cylinder.



5. INSTALL CYLINDER BOOT


    C190247E01
  1. Apply lithium soap base glycol grease to a new cylinder boot.

  1. Install the cylinder boot onto the disc brake cylinder.

    NOTICE:
    Securely install the cylinder boot into the grooves of the disc brake cylinder and piston.