FRONT DOOR > ADJUSTMENT |

| 1. INSPECT FRONT DOOR |
Check that the clearance measurements are within the standard ranges.

| Area | Measurement | Area | Measurement |
| A | 4.1 to 7.1 mm (0.161 to 0.280 in.) | G | 1.1 to 4.1 mm (0.043 to 0.161 in.) |
| B | 4.4 to 7.4 mm (0.173 to 0.291 in.) | H | 4.3 to 7.3 mm (0.169 to 0.287 in.) |
| C | 4 to 7 mm (0.157 to 0.276 in.) | I | 3.5 to 6.5 mm (0.138 to 0.256 in.) |
| D | 4 to 7 mm (0.157 to 0.276 in.) | J | 4.6 to 7.6 mm (0.181 to 0.299 in.) |
| E | 5.2 to 8.2 mm (0.205 to 0.323 in.) | K | 4.2 to 7.2 mm (0.165 to 0.283 in.) |
| F | 5.9 to 8.9 mm (0.232 to 0.350 in.) | L | 9 to 12 mm (0.354 to 0.472 in.) |
| 2. ADJUST FRONT DOOR |
Disconnect the cable from the negative battery terminal.
![]() |
Apply strips of protective tape to the door panel and fender panel, as shown in the illustration.
![]() |
Open the door, and then disengage the 5 clips.
Remove the front fender splash shield from the gap between the fender and door.
![]() |
Using SST, adjust the door horizontally and vertically by loosening the body side hinge bolts.
Tighten the body side hinge bolts after the adjustment.
![]() |
Adjust the door horizontally and vertically by loosening the door side hinge bolts.
Tighten the door side hinge bolts after the adjustment.
![]() |
Using "Torx" socket wrench T40, adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.
Using "Torx" socket wrench T40, tighten the striker mounting screws after the adjustment.
![]() |
Install the front fender splash shield with the 5 clips.
Connect the cable to the negative battery terminal.