REAR BRAKE > INSTALLATION |
| 1. INSTALL REAR DISC |
Align the matchmarks of the disc and axle hub and install the disc.
| 2. INSTALL REAR DISC BRAKE CYLINDER HOLE PLUG |
Install a new hole plug onto the disc brake cylinder mounting.
| 3. INSTALL REAR DISC BRAKE BUSH DUST BOOT |
![]() |
Apply lithium soap base glycol grease to a new dust boot.
Install the dust boot onto the disc brake cylinder mounting.
| 4. INSTALL REAR DISC BRAKE CYLINDER SLIDE BUSH |
![]() |
Apply lithium soap base glycol grease to a new slide bush.
Install the slide bush onto the disc brake cylinder mounting.
| 5. INSTALL REAR DISC BRAKE CYLINDER MOUNTING |
![]() |
Install the disc brake cylinder mounting with the 2 bolts and 2 washers.
| 6. INSTALL REAR DISC BRAKE PAD SUPPORT PLATE |
Install the 4 pad support plates onto the disc brake cylinder mounting.
| 7. INSTALL REAR DISC BRAKE PAD WEAR INDICATOR PLATE |
Install the indicator plate onto the inner side brake pad.
| 8. INSTALL REAR DISC BRAKE ANTI SQUEAL SHIM |
Install the 2 anti squeal shims onto the brake pads.
| 9. INSTALL REAR DISC BRAKE PAD |
Install the 2 disc brake pads with anti squeal shims onto the disc brake cylinder mounting.
| 10. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY |
![]() |
Apply lithium soap base glycol grease to the 2 slide pins.
![]() |
Install the disc brake cylinder onto the disc brake cylinder mounting with the 2 slide pins.
| 11. INSTALL REAR FLEXIBLE HOSE |
![]() |
Install the flexible hose with the union bolt and a new gasket.
| 12. BLEED BRAKE LINE |
Turn the ignition switch on (IG).
Remove the brake master cylinder reservoir filler cap assembly.
Add brake fluid until the fluid level is between the MIN and MAX lines of the reservoir.
Repeatedly depress the brake pedal and bleed air from the bleeder plug of the front disc brake cylinder RH.
Repeat the step above until the air is completely bled, and then tighten the bleeder plug while depressing the brake pedal.
Bleed the air from the bleeder plug of the front disc brake cylinder LH using the same procedure as for the RH side.
With the brake pedal depressed, loosen the bleeder plug of the rear disc brake cylinder RH, continue to hold the brake pedal and allow brake fluid to be drained from the bleeder plug while the pump motor operates.
When there is no more air in the brake fluid, tighten the bleeder plug, and then release the brake pedal.
Bleed the air from the bleeder plug of the rear disc brake cylinder LH using the same procedure as for the RH side.
Turn the ignition switch off (IG).
Inspect for brake fluid leaks.
Check and adjust the brake fluid level .
| 13. INSTALL REAR WHEEL |