WIPER AND WASHER SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Connect a Techstream to the DLC3.
Turn the ignition switch ON.
Turn the tester on.
Read the DATA LIST according to the prompts displayed on the tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Wiper Turn Position SW | Rear wiper turn position switch signal/ON or OFF | ON: Rear wiper in turning position OFF: Rear wiper in other position | - |
| Wiper Retracting SW | Rear wiper retracting switch signal/ON or OFF | ON: Rear wiper in retracting position OFF: Rear wiper in other position | - |
| Power Window Position | Back window courtesy switch signal/ON or OFF | ON: Back window door is open OFF: Back window door is closed | - |
| PERFORM ACTIVE TEST |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Perform the Active Test according to the prompts displayed on the tester.
| Tester Display | Test Part | Control Range | Control Range |
| Rear Wiper | Rear wiper | ON/OFF | - |